Triumph TR6 PI Operation Manual page 222

CLUTCH
Refitting
5. Align the pipe in position on the car.
6. Screw the flexible pipe lower union to the slave
cylinder.
7. Secure the pipe in its retaining clips.
8. Connect the pipe unions to the clutch master cylinder
and the upper end of the flexible pipe.
9. Bleed the system 33.15.01.
Removing
I. Disconnect the fluid pipe union from the clutch
master cylinder.
2. Disconnect the fluid pipe union at the upper end of
the flexible pipe.
3. Release the fluid pipe from its retaining clips and
remove the pipe from the car.
4. Unscrew the flexible pipe union at the slave cylinder.
FLUID PIPE
- Remove and refit
33.15.09
NT 2695
Refitting
6. Reverse instructions I to 5.
7. Bleed the system.
Removing
1.
Lift the rubber boot at the front of the master
cylinder bracket to expose the clutch pedal/master
cylinder linkage. (Right hand steering models only).
2. Remove the split pin, washer and clevis pin securing
the clutch pedal to the master cylinder push rod.
3. Disconnect the fluid pipe from the master cylinder.
4. Remove the two bolts and spring washers securing the
master cylinder flange to the mounting bracket, or·
scuttle as appropriate.
5. Withdraw the master cylinder.
o
NT 2697
_ _ _ _ _ _ _-Tt--
33.20.01 - Remove and refit
MASTER CYLINDER
33.15.09
33.20.01 Triumph TR6 Manual. Part No. 545277 Issue 1