Triumph TR6 PI Operation Manual page 417

WINDSCREEN WIPERS AND WASHERS
Dismantle
Assemble
WINDSCREEN WASHER PUMP AND RESERVOIR -
LUCAS TYPE 9SJ
84.10.24
I. Rotate the cover anticlockwise to release the bayonet
fitting. Lift the pump and cover assembly from the
reservoir.
2. Remove two screws.
3. lift off the pump housing.
4. Carefully withdraw the rotor and rotor drive plate.
5, Lift out the rubber '0' ring.
6.
lift off the seal housing.
7. Withdraw the seal from the shaft.
8. Remove the plate.
9. Withdraw the small rubber disc from the shaft.
It is not advisable to attempt to overhaul the pump
assembly. If the pump operation is suspect repair by
replacement of the complete pump and cover assembly.
The motor is a sealed unit and can not be serviced. It is
possible to dismantle and clean the interior of the pump as
detailed below but no individual Stanpart spare parts are
available.
- Overhaul
Ill. Reverse instructions 1 to 9.
Triumph TR6 Manual. Pan No. 545277 Issue 1
86.10.24 Sheet 2