Triumph TR6 PI Operation Manual page 475

ELECTRICAL
Refitting
12. Reverse instructions 1 to 11. Connect the Lucar
connectors as shown.
Removing
1. Open the luggage boot lid.
2. Remove the floor carpet.
3. Remove the spare wheel cover panel.
4. Remove six screws and withdraw the appropriate
small rear trim panel.
5. Turn back the side trim panel on the appropriate side.
6. Pull four bulb holders from the lamp base.
7. Disconnect six Lucar connectors.
8. Remove the bulbs from the bayonet fittings.
9. Remove six nuts, spring washers and washers.
10. Withdraw the lamp from th~ panel.
11. The four lenses are attached to the lamp base with
Posidrive screws. A lens may be replaced individually
after removing the lamp.
~(d:'
;~
86.40.70
LAMPS
Rear lamp assembly - remove and refit
GN
R
R
NTO 746
Refitting
10. Reverse instructions I to 9. If any difficulty is
experienced positioning the wires or panel grommet
remove the floor carpet, spare wheel cover panel and
spare wheel. A rubber plugged access hole exists on
the inner panel in line with the panel grommet
position.
Removing
1. Remove two screws and lift off the chrome cover.
2. Disengage the small lens lugs from the rubber
mouldin~
3. Remove the two bulbs from the bayonet fittings.
4. Open the luggage boot lid.
5. Locate the plate illumination lamp wires at a harness
brake out point accessible through an aperture in the
rear valance panel.
6. Disconnect two wires from the four-way snap
connector.
7. To facilitate refitting tie a suitable length of cord
firmly to the wires.
8. Carefully pull the wires and cord through the panel
grommet.
9. Remove two nuts, spring washers and washers.
Remove the lamp base from the bumper.
LAMPS
Plate illumination lamp - remove and refit
86.40.86
GP Green/purple wire
B Black wire
GR Green/red wire
GW Green/white wire
R Red wire
GN Green/brown wire
86.40.70
86.40.86
Triumph TR6 Manual. Part No. 545277 Issue I