Table of Contents
Advertisement
FUEL SYSTEM PI
IS.
Re·check the metering readings on numbers three and
six Intakes and re·adjust If necessary.
16. Adjust the fast Idle speed by pul1lng the cold start
cable out of the adjuster with the cam turned to its
maximum 11ft position. Turn the adjusting screw
against the cam until the engine revolutions maintain
a steady
1500
to
1800
r.p.m.
NOTE: Do not pull the cold start cable with the control
knob on the control panel since it will also operate
the excess fuel lever on the metering unit thereby
Increasing the quantity of fuel delivered to the
Injectors.
17.
Turn the throttle adjusting screw so that It just
touches the countershaft operating lever and secure
with the lock nut. See instruction
6.
20.
Adjust the throttle and cold start cables to remove
excessive slack and secure with the locknuts.
21.
Stop the engine and refit the
air
intake manifold.
19.70.01.
18.
As a check to ensure that
all
the butterflies
are
fully
closed hold a finger over the end of the air valve pipe
so that the engine stalls.
19.
Start the engine and by means of the air valve
adjusting screw regulate the alr bleed to give an idling
speed of
750
to
800
r.p.m.
Data
Idling speed
Fast idling speed
19.20.05 P J. Sheet 4
750
to
800
r.p.m.
.1500
to
1800
r.p.m.
Triumph TR6 Manual.
Pan
No. $4$277 Issue I
Hide quick links:
Advertisement
Table of Contents
