Triumph TR6 PI Operation Manual page 266

Sun wheel end-float
85. Insert dummy mainshaft tool LI85A and turn sun
wheel until shaft engages the planet carrier and
uni-directional clutch splines.
86. Fit a thrust washer of known thickness plus steel and
bronze thrust washers over dummy shaft until they
rest on sun wheel.
85
\
OVERDRIVE 'A' TYPE
87. Fit brake ring to front casing, tap fully home.
88. Fit front casing to rear until abutted on washers on
dummy shaft.
89. Use feeler gauges to measure gap between cases which
should be the thickness of the additional washer
fitted at 86 minus the required end-float 0-008 to
0-014 in (0-20 to 0'35 mm).
Example (a):
Noted thickness of additional washer 0·125 in
Gap between flanges 0·114in
End-float 0'0 II in
As this end-float is within limits the existing
washers are satisfactory_
Example (
b):
Noted thickness of additional washer 0-125 in
Gap between flanges 0.123 in
End-float 0'002 in
In this- example 0'002 in end-float is not sufficient
and a steel washer 0-006 to 0'012 in thicker than the
existing washer must be fitted.
Washers are available in the following thicknesses
in inches:
Part No_ 500588 Suffix A. 0-113 to 0-114'
B.
0-107 to 0-108; C. 0-101 to 0'102; D. 0'095 to 0'096;
E_ 0-089 to 0'090' F. 0'083 to 0·084; G_ 0'077 to
0'078.
90. On selection of correct washer, separate casings.
Continued
Triumph TR6 Manuat. Part No. 545277 Issue
t
40.20.lOA Sheet 8