Triumph TR6 PI Operation Manual page 387

Refitting
7. Reverse instructions I to 6.
Removing
1. Relieve the load on the cross member using a jack
positioned beneath the chassis frame.
2. Slacken the two nuts securing the support bracket to
the radiator.
3. Remove the two nuts and bolts securing the support
brackets to the cross member.
4. Remove the nut and bolt securing the air cleaner
bracket to the support bracket.
5. Remove the six bolts securing the cross member to
the chassis frame.
6. Pull the support brackets clear and remove the cross
member from the vehicle.
FRONT CROSS MEMBER (TUBULAR)
- Remove and refit
FRONT VALANCE SPOILER
- Remove and. refit
76.10.05
76.10.46
BODY
•• The spoiler fitted to later models is secured to the body by
five bolts with plain washers and nuts. Note the location of
the washers when removing the spoiler.
**
GEARBOX TUNNEL COVER TRIM PAD
- Remove and refit 76.13.06
Removing
1. Remove the screw and cup washer securing the front
end of the trim pad to the gearbox tunnel cover.
2. Disengage the rear end of the·trim pad from the fascia
support bracket. Lift off the trim pad.
Refitting
3. Reverse instructions I and 2.
Triumph TR6 Manual. Part Nll. 545277 Issue 3
76.10.05
76.13.06