Table of Contents
Advertisement
OVERDRIVE 'A' TYPE
Accumulator
51.
Fit rings to piston - two wide inners· four thin
outers.
52.
Fit piston to sleeve using tool Ll79.
53.
Fit
'0'
ring to sleeve.
54.
Ease sleeve into bore and
push home using
accumulator tube.
55.
Fit accumulator spring and shims (where fitted).
CAUTION: When accumulator spring shims are fitted
they must be replaced. Fitting washers of greater
thickness can cause a pressure build-up where a spring
becomes coil-bound and the blow-off holes are not
uncovered by the piston.
56.
Fit
'0'
ring to solenoid bracket recess.
57.
Fit solenoid bracket and gasket.
58.
Fit and tighten evenly the two red-headed set screws.
59.
Fit and tighten nuts and washers.
Solenoid
60.
Fit spacers and solenoid-operating lever, securing with
clamp bolt.
61.
Fit solenoid, inserting plunger to yoke of operating
lever.
62.
Fit and tighten two solenoid retaining screws.
NOTE: when the overdrive is rebuilt the solenoid will
require adjustment (40.22.01).
Continued
, 4O.20.IOA Sheet 5
NT2753
Triumph TR6 Manual.
Pan"
No. 545277 Issue I
Hide quick links:
Advertisement
Table of Contents
