Table of Contents
Advertisement
Refitting
3.
Press new bush into position ensuring that it is
centralised in the damper eye.
4.
Refit the damper to the car 60.30.02 .
Removing
1.
Jack up the car, support the chassis and remove the
frontwheel.
2.
Locate a jack under the spring pad of the lower
wishbone and raise the jack to relieve the upper
wishbone of road spring tension.
3.
Remove the two nuts, plain washers and bolts
securing the outer end of the upper wishbone to the
ball joint housing.
4.
Detach the ball joint housing and the vertical link
from the upper wishbone arms. Ensure that strain is
not imposed on the front brake hose.
5.
Remove the four bolts and spring washers securing
the fulcrum bracket to the chassis.
6.
Withdraw the fulcrum bracket complete with the
upper wishbone arms..
7.
Remove the split pins, slotted nuts and plain washers
securing the wishbone arms to the fulcrum bracket.
8.
With4raw the wishbone arms oomplete with rubber
bushes.
FRONT DAMPER BUSH
- Remove and refit
Removing
I.
Remove the damper from the car 60.30.02.
2.
Remove the damper lower bush.
. UPPER WISHBONE
- Remove and refit
60.30.07
60.35.01
FRONT SUSPENSION
Refitting
9.
Reverse instructions 1 to 8. When refitting the bolts
securing the ball joint housing to the outer ends of
the wishbone arms the outer bolt is entered from the
rear: the inner bolt is entered from the front.
Triumph TR6 Manual.
Pan
No. 545277 lJlue I
60.30.07
60.35.01
Hide quick links:
Advertisement
Table of Contents
