Triumph TR6 PI Operation Manual page 355

REAR SUSPENSION
REAR HUB OIL SEALS
Instructions I to 9,14 to 19 and 21 to 26, 64.15.14.
Removing
I. Remove the rear brake drum 70.10.03.
2. Tap the wheel stud towards the brake backplate until
the stud splines are released from the hub flange.
3. Remove the stud.
64.15.15
64.15.26
- Remove and refit
REAR HUB WHEEL STUD
- Remove and refit
Service Tools S317, S318, M86C
7. Reverse instructions I to 7.
Refitting
Refitting
4. £nter the stud in the hub flange ensuring that the
tapered faces are clean.
5. Using suitable packing (e.g. a short length of steel
tubing and washers) draw the stub into position.
6. Remove the packing and fit the brake drum, and road
wheel 70.10.03.
64.20.01
64.20.17
As Operation 64.20.01.
REAR SPRING
-Remove and refit
Removing
I. Jack up the car and support the chassis on stand(s).
2. Remove the road wheel and release the handbrake.
3. Support the trailing arm with ajack.
4. Remove the locknut, nut, washers and rubbers
securing the damper. link to the trailing arm.
5. Carefully lower the jack under the trailing arm until
the road spring is released of tension.
6. Withdraw the road spring and the upper and lower
rubber insulating rings.
REAR SPRING SEAT RINGS
- Remove and refit
Triumph TR6 Manual. Pan No. 545277 Issue
J
64.15.15
64.20.17