Triumph TR6 PI Operation Manual page 361

BRAKES
1 . . .
..
~
REAR BRAKE DRUM
5. Reverse instructions I to 4.
Refitting
Removing
I. Jack up the car and remove the rear wheel.
2. Release the handbrake.
3. Remove the two countersunk screws securing the
brake drum to the hub.
4. Withdraw the brake drum.
70.10.03
70.10.10
FRONT DISC
- Remove 3ad refit
- Remove and refit
Removing
I. Jack up the car and remove the front wheel.
2. Detach the caliper and remove the front hub
60.25.01/02.
3.
Remove the four bolts and spring washers securing
the disc to the hub flange.
4. Withdraw the disc.
Refitting
5. Align the countersunk holes in the drum with the
tapped holes in the hub.
6. Engage the wheel studs in the drum.
7. Slide the brake drum into position. If the brake shoes
were disturbed they may require to be centralised on
the backplate to allow drum entry.
8. Fit and tighten the two countersunk screws.
9. Fit the road wheel and remove the jack.
Refitting
4.
Reverse instructions I to 3.
Removing
I. Remove the front hub 60.25.01/02.
2. Slacken the front lower nut, washer and bolt securing
the disc mounting lug to the vertical link.
3. Withdraw the disc shield.
FRONT DISC SHIELD
- Remove and refit 70.10.18
\
rH252b
Triumph TR6 Manual. Part No. 545277 Issue 1
70.10.03
70.\0.18