Table of Contents
Advertisement
__
.~I
NT2522
NT;;463
STEERING
57.25.01
Refitting
10.
Fit the rack mounting rubbers on the inboard side of
the rack flanges. Ensure the lip of the mountings
engages the straight edges of the flanges.
II.
Centralise the steering rack and place it in position on
the chassis.
12.
With the steering wheel centred engage the pinion in
the universal joint.
13.
Fit the 'U' bolt and bracket-assemblies.
14.
Fit the angle plates (angles inboard) plain washers and
nuts to the 'U' bolts.
15.
Using Tool S34I, compress the mounting rubbers
until approximately 1/8 in. (3 mm) remains exposed
beyond the edge of the .'U' bolt brackets.
16.
Ensure that the angle of the plates is in hard contact
with the chassis' and tighten the 'U' boI.t nuts.
Remove Tool S341.
17.
Connect the tie rod ball joints to the steering arms.
18.
Fit the clamp bolt, plain washer and nut to the
universal joint and pinion. Tighten.
19.
Fit the bonding strap and plug to the damper plug.
20.
Fit the front wheels and remove the jack.
.
21.
Check and adjust front wheel track.
Removing
I.
Jack up the car and remove the front road wheels.
2.
Disconnect the tie rod outer ball joints from the
steering arms.
3.
Remove the bolt, plain washer and nut securing the
universal joint to the rack pinion.
4.
Remove the plug from the damper plug and release
the bonding strap.
5.
Remove the four nuts, plain washers and two angle
plates securing the rack 'U' bolts to the chassis.
6.
Withdraw the 'U' bolts and bracket assemblies.
7.
Slide the rack forward to release the pinion from the
universal joint.
8.
Remove the rack.
9.
Remove the rack mounting rubbers.
~
Remove and refit
Service Tool: S341
STEERING RACK AND PINION
Triumph TR6 Manual. Part No. 545277 Issue I
57.25.01
Hide quick links:
Advertisement
Table of Contents
