Triumph TR6 PI Operation Manual page 32

(7) Check/top up carburetter piston(s) damper(s)
I. Unscrew hexagon plug from top of carburetter.
2. Withdraw plug and damper assembly from
carburetter.
3. Replace plug and damper assembly to check oil level,
which if correct will offer resistance to the assembly
when the bottom of the plug threads are
!4
in (6 mm)
above the rim of the dashpot.
4. If necessary, again withdraw plug and damper
assembly and add a recommended engine oil, using an
oil can, until the oil level is correct.
5. Replace plug and damper assembly.
6. Screw hexagon plug firmly in position.
(8) Drain engine oil and refill
NOTE: This operation is best carried out when the engine is
warm and with the vehicle standing level on a ramp or
over a pit.
I. Wipe clean the engine drain plug and surrounding
area.
2. Place a suitable receptical under the drain plug.
3. Unscrew the drain plug slowly until oil begins to
escape.
4. When the rate of oil flow lessens, remove drain plug
from sump and allow oil to drain completely.
5. Wipe clean the drain plug and replace it in sump.
6. Tighten drain plug to 20 to 25 Ibf ft. (2·8 to 3·5 kgf
m).
7. Remove oil filler cap.
8. Add a recommended engine oil, via filler cap, to bring
level just below high mark on dipstick. DO NOT
OVERFILL.
9. Replace oil filler cap.
10. Allow time for added oil to drain into sump, then
check ftnal oil level on dipstick.
Triumph TR6 M'lIluul. P<lft
No.
54S277 Issue I
MAINTENANCE
MT 2811 C
10.00.07