Triumph TR6 PI Operation Manual page 289

OVERDRIVE-J TYPE
Removing
I. Remove the overdrive from the car. 40.20.07.
2. Remove the sump and filter. 40.10.01.
3. Remove the pump plug, using tool L354A.
4. Remove the non-return valve spring.
5. Remove the steel ball.
6. Remove the non-return valve seat.
7. Work the pump body out of the main casing.
8. Remove the pump plunger assembly.
Refitting
9. Position the pump plunger assembly in the main case.
10. Fit the pump body in the main casing, ensuring that
the flat on the body faces towards the pressure ftlter
housing.
11. Fit the non-return valve seat.
12. Fit the steel ball.
13. Fit the non-return valve spring into the pump plug.
14. Fit the plug and tighten to a torque of 161bfft (2·2
kgfm).
15. Clean the sump ftlter and replace.
16. Fit the sump with a new joint.
17. Tighten the sump bolts to a torque of 61bf ft (0:8 kgf
m).
18. Refit the overdrive to the car. 40.20.07.
OIL PUMP
- Remove and refit
OIL PUMP
- Overhaul
40.18.01
40.18.04
I. Remove the pump plunger assembly. 40.18.01.
2. Check that the strap is a good fit on the mainshaft
cam.
3. Check that there is no excess play between the strap
and the plunger.
4. If the pump plunger assembly is worn or damaged,
this must be replaced as a complete assembly.
5 Check that the '0' rings on the pump body and the
plug are perfect; if not, these must be replaced.
6. Refit the pump plunger assembly. 40.18.01.
4O.18.0lJ
4O.18.04J
Triumph TR6 Manual. Part No. 545277 Issue
J
/(jJ
... VLANO