Triumph TR6 PI Operation Manual page 330

Removing
I.
Remove thll speedometer and tachometer from the
facia.
2. Release the wiring harness socket from the steering
lock.
3.
Remove the domed protective cover from the steering
column upper bracket nuts.
4. Remove the nuts, plain washers and bolts from the
steering column upper bracket.
5. Remove the top half of the steering column upper
bracket.
6. Remove the nuts, spring washers and bolts securing
the anti-torque strap to the scuttle.
7. Remove the cable harness cover from the underside
of the steering column.
8.
Withdraw the anti-torque strap from the steering
lock.
9. Rotate the steering column 180
0
to expose the
sheared heads of the two bolts securing the steering
lock to the steering column.
10. Using a centre-punch mark the centre of the two
shear bolt heads.
II. Using a small chisel unscrew the shear bolts. If this
method proves unsuccessful drill the shearbolts and
unscrew them with an 'Easiout' type extractor.
12. Remove the steering lock.
STEERING COLUMN LOCK/IGNITION/
STARTER SWITCH
- Remove and refit
57.40.31
STEERING
Refitting
13. Offer up the steering lock and clamp bracket to the
steering column.
14. Fit two new shearbolts. Evenly tighten the shearbolts
until the heads shear.
15. Reverse instruction I to 9.
NT2465
Triumph TR6 Manual. Part No. 545277 Issue 1
57.40.31