Table of Contents
Advertisement
Refitting
4.
Screw the switch into the block. The thread is
tapered so do not attempt to seat the switch
shoulder.
5.
Connect the Lucar connector.
Removing
I.
Locate the switch on the left hand side of the engine
below the ignition distributor.
2.
Disconnect the Lucar connector.
3.
Using a spanner, unscrew the switch from the block.
Removing
l.
Remove the drivers or passengers seat 76.70.04 or
76.70.05.
2.
Disconnect the electrical harness plug.
3.
Remove single bolt and spring washer. Lift out the
buckle and switch unit.
SWITCHES
- Oil pressure switch - remove and refit
SWITCHES
Seat belt - drivers belt switch -
remove and refit
Seat belt - passengers belt switch -
remove and refit
Later U.S.A. market vehicles only.
86.65.30
86.65.31
86.65.32
ELECTRICAL
NTO 718
NTO 159
Refitting
4.
Reverse instructions I to 3. Seal the large plain
washer to the floor panel with an approved sealer to
ensure a waterproof joint.
Triumph TR6 Manual. Part No. S4S271 Issue I
86.65.30
86.65.32
Hide quick links:
Advertisement
Table of Contents
