Triumph TR6 PI Operation Manual page 68

ENGINE
CRANKSHAFT PULLEY
- Remove and refit
Special tool 5341
12.21.01
Removing
1. Isolate the battery.
2. Remove the radiator 26.40.01.
3. Remove the fan blades.
4. Remove the fan adaptor ~ Carburetter engines only
26.25.06.
5. Remove the chassis cross tube, 76.10.05.
6. Remove the fan belt.
7. Remove the special bolt securing the fan extension.
8. Remove the fan .extension by tapping it with a
hammer to free it from its locating dowels.
9. Remove the steering rack 'U' bolts and ease the rack
forward sufficiently to withdraw the pulley without
fouling, 57.25.0 I instructions 5 and 6.
10. Withdraw the crankshaft pulley.
Refitting
11. Check that the crankshaft key is in position and the
key-way in the pulley is free from burrs. Drift the
pulley on to the crankshaft squarely until it butts
against the oil seal sleeve in the timing cover.
12. Check that the two fan extension location dowels are
in position and their locating holes are free from
burrs. Fit the extension and secure with the special
bolt.
13. Refit the steering rack using special tool 5341,
57.25.01 instructions 11 to 16.
14. Refit and adjust the fan belt 26.20.07.
15. Reverse instructions I to 5.
12.21.01
I
I
Triumph TR6 Manual. Part No. 545277 Issue 1
II