Table of Contents
Advertisement
SPEEDOMETER CABLE - COMPLETE
INSTRUMENTS
Refitting
8.
Reverse instructions 1 to 7. Seal the grommet to the
bulkhead with Seelastik SRSI.
Removing
I;
Unscrew the knurled retainer securing the cable to the
speedometer.
2.
Raise the right hand side of the rear gearbox <;over
carpet.
3.
Remove the three screws and washers. Pull the access
plate away from the gearbox cover.
4.
Unscrew the knurled retainer securing the cable to the
angle drive.
S.
To assist refitting, carefully note the cable positions
relative to other components.
6.
Working from below the vehicle, detach the cable
from the clip securing it to the body.
7.
Manoeuvre the cable through the grommet aperture
and detach it from the vehicle.
(Overdrive models)
- Remove and refit
SPEEDOMETER CABLE - INNER
- Remove and refit
88.30.06
88.30.07
Removing
I.
Unscrew the knurled retainer securing the cable to
the speedometer.
2.
Using long nosed pliers, withdraw the inner cable.
Take care not to contaminate the upholstery or
fittings with grease.
Refitting
3.
Sparingly grease the inner cable. Do not use oil.
4.
Feed the inner cable into the outer cable rotating it
slightly to assist operation.
5.
Withdraw the inner cable about 8 ins (200 mm) and
wipe off surplus grease. Re-insert the inner cable,
rotating it slightly to assist engagement of the squared
end to the drive gear.
6.
Engage the inner cable to the speedometer.
7.
Refit the knurled retainer.
Triumph TR6 Manual.
Pan
No. 545277 Issue 1
88.30.06 Sheet 2
88.30.07
Hide quick links:
Advertisement
Table of Contents
