Table of Contents
Advertisement
REAR WHEEL CYLINDER
- Overhaul
70.60.26
BRAKES
I.
Jack up the car and remove the rear road wheel.
2.
Remove the hub extension (wire wheels only).
Remove the brake drum.
3.
Remove the brake shoes.
4.
Disconnect the handbrake cable from the backplate
lever.
5.
Remove the clip securing the rubber boot to the
wheel cylinder.
6.
Withdraw the rubber boot.
7.
Withdraw the piston complete with seal from the
wheel cylinder.
8.
Examine the piston and cylinder bore for scoring,
wear or damage. If either are damaged or worn or
doubt exists, the cylinder assembly must be renewed.
9.
Remove the seal from the piston.
10.
Fit a new seal to the piston ensuring that the seal lip
faces towards the closed end of the cylinder.
II.
-Fit the rubber boot to the piston, smear the piston
and cylinder with clean brake fluid and insert the
piston into the cylinder.
12.
Ensure the rubber boot is fitted snugly to the
cylinder and secure with the clip.
13.
Fit the brake shoes, brake drum and hub extension if
applicable.
14.
Connect the handbrake cable to the backplate lever.
15.
Fit the road wheel and remove the jack.
16.
Bleed the brakes.
Triumph TR6 Manual. Pact No. 545277 Issue J
70.60.26
Hide quick links:
Advertisement
Table of Contents
