Triumph TR6 PI Operation Manual page 421

Removing
1. Remove the harness plug from the limit switch.
2. Remove four screws. Lift off the gearbox cover.
3. Remove the crankpin spring clip by withdrawing
sideways.
4. Remove the washer.
5. Carefully withdraw the connecting rod.
6. Remove the washer.
7. Remove two bolts, spring washers and washers.
Remove the strap and rubber sleeve. Collect up the
rubber pad.
8. Manoeuvre the motor to allow the cross-head, rack
and tube assembly to be released. Remove the motor
from the vehicle.
WINDSCREEN WIPER MOTOR
Remove and refit
84.15.12
WINDSCREEN WIPERS AND WASHERS
NT0694
Refitting
9. Ensure that the connecting rod is removed as detailed
above.
10. Position the motor so that the cross-head, rack and
tube assembly are correctly located to the motor
guide channel.
11. Position the rubber pad. Locate the strap and rubber
sleeve. Secure with two bolts, spring washers and
washers.
12. Fit the washer.
13. Lubricate the final gear crankpin with Shell Turbo 41
oil.
14. Lubricate the cross-head end of the connecting rod,
including the pin, with Ragosine Listate grease.
15. Carefully insert the connecting rod.
16. Fit the washer.
17. Fit the spring clip by inserting sideways.
18. Position the gearbOX cover. Secure with four screws.
19. Fit the harness plug to the limit switch.
Triumpt. TR6 Manual. Part No. 545277 Issue J
13
NTOB63
1l4.lS.12