Triumph TR6 PI Operation Manual page 401

Refitting
5. Reverse instructions 1 to 4.
Removing
1.
Remove the gearbox cover side trim pads 76.13.06.
2. Prise off the caps and remove the two nuts and bolts.
3. Remove the four bolts and washers securing the
bracket to the floor.
4. Lift off the bracket.
FASCIA SUPPORT BRACKET
- Remove and refit
FASCIA - METAL
- Remove and refit
76.46.09
76.46.10
BODY
"'y
-----
N T 2396
Removing
1. Remove the veneered fascia 76.46.01.
2. Remove the steering column 57.40.01.
3. Remove the two screws and washers securing the
reinforcement bracket to the fascia.·
4. Remove the control cowl 76.25.02.
5. Remove the fascia support bracket 76.46.09.
6. Slacken the two clips and disconnect the cold air
hoses from the 'V' pieces.
7. Pull the snap connector from the glovebox lamp
switch and pull out the bulbholder.
8. Remove the buzzer (if fitted) 86.55.13.
9. Remove the two bolts and washers securing the fascia
to the 'A' post.
10. Remove the five nuts and washers securing the fascia
to the upper crash pad.
II. Remove the fascia from the car.
Refitting
12. Reverse instructions 1 to II.
FASCIA CRASH PAD - LOWER
- Remove and refit
76.46.12
Removing
1. Remove the veneered fascia 76.46.01.
2. Remove the metal fascia 76.46.10.
3. Remove the three nuts and ldck washers.
4. Pull the overlapping material away from the fascia
and remove the crash pad.
Refitting
5. Reverse instructions I to 4, securing the material
overlap to the fascia with Dunlop S758 adhesive.
Triumph TR6 Manual. Part No. 545277 Issue 1
76.46.09
76.46.12