Triumph TR6 PI Operation Manual page 481

ELECfRlCAL
RELAYS
Hom relay - remove and refit
86.55.09
Later vehicles only.
-------,o=.-----------~-----
----0"-------
Removing
I. Lift the bonnet and locate the hom relay on the left
hand front wheelarch closing panel. The horn relay is
identified by being connected to wires with purple as
the primary coloul':
2. Disconnect four Lucar connectors.
3. Remove two nuts, spring washers, washers and
screws. Lift the relay from the vehicle.
Refitting
4. Reverse instruction I to 3. Connect the Lucar
connectors as follows:
Purple/black wire to terminal WI
Purple wire to terminal W2
Purple/yellow wire to terminal Cl
Purple wire to terminal C2
Refitting
4. Connect two Lucar connectors.
Green wire or light green/slate wire (as fitted) to
terminal B.
Light green/brown wire to terminal L.
5. Fit the flasher unit to the clip.
Removing
I. Locate the flasher unit mounted in a clip attached to
the bulkhead end panel adjacent to the passengers
feet.
2. Pull the flasher unit from the clip
3. Disconnect two Lucar connectors.
86.55.11
FLASHER UNIT
Tum signal flasher unit - remove and refit
86.55.09
86.55.11
Triumph TR6 Manual. Part No. 545277 Issue I