Triumph TR6 PI Operation Manual page 267

OVERDRIVE 'A' TYPE
Clutch sliding member
91. Press bearing evenly into thrust ring, secure with
circlip.
92. Press thrust ring assembly on the hub of clutch sliding
member, secure with circlip.
93. Fit sliding member assembly engaging with splines of
sun wheel.
Re-assemble casings
'94. Coat flanges of brake ring with jointing compound
and fit to front case.
95. Fit steel washer, selected at 89, then bronze washer
into recess in front case; use a smear of grease to
retain them in position,
96. Join the front to rear case locating thrust ring posts
through holes in front case, ensure thrust washers
(95) are still located.
97. Fit and tighten nuts securing front to rear case.
98.
Fit bridge piece.s securing with nuts locked with new
tab washers.
99. Fit eight clutch springs, four short ones on inner
posts.
100. Fit overdrive assembly to gearbo.xAO.20.07.
40.20.l0A Sheet 9
Triumph TR6 Manual.. Part N-o. 545277 Issue I