Table of Contents
Advertisement
Refitting
18.
Check the alignment of the clutch splines, move the
clutch throwout bearing to the rear extent of its
travel and engage top gear.
19.
Manoeuvre the gearbox into position, if necessary
rotating the drive flange to align the input shaft
splines with those of the clutch.
20.
Fit the upper (nine) enginefbellhousing attachments.
21.
Raise the ramp and using the ramp jack, lift the
engine.
22.
Refit
the
lower
(seven)
enginefbellhousing
attachments.
23.
Place the mounting assembly in position and lower
the ramp jack.
24.
Refit the clutch slave cylinder push rod to the cross
shaft lever.
25.
Lower the ramp.
26.
Secure the mounting plate to the chassis frame.
27.
Refit the exhaust support bracket.
28.** Refit the two bolts and nuts and on later models the
steady strap.
~*
29.
Connect the speedometer cable to the gearbox.
30.
Connect the propeller shaft to the gearbox drive
flange.
31.
Refit the transmission cover panel and carpet.
76.25.07
32.
Refit the gearlever 37.16.04.
33.
Refit the fascia support bracket 76.46.09.
34.
Refit the transmission sidl trim panels 76.13.06
35.
Refit both front seats 76.70.04-05
36.
Re-connect the battery.
SYNCHROMESH GEARBOX
26
~
~
Triumph TR6 Manual. Pari No.
S4S277
Issue 2
37.20.01 Sheet 2
Hide quick links:
Advertisement
Table of Contents
