Triumph TR6 PI Operation Manual page 395

Removing
1. Remove the bolt and lockwasher securing the cowl
reinforcement to the fascia.
2. Depress the four buttons and pull off the control
knobs.
3. Unscrew and remove the four bezels.
4. Remove the two screws securing the cowl to the
fascia.
5. Withdraw the cowl, noting the control positions for
refitting.
CONTROL COWL
- Remove and refit 76.25.03
BODY
Refitting
6. Reverse instructions I to 5.
GEARBOX TUNNEL COVER
- Remove and refit
76.25.07
Removing
1. Remove the seats 76.70.04/76.70.05.
2. Remove the fascia support bracket 76.46.09.
3. Remove the front gearbox cover carpet 76.49.01.
4. Remove the rear gearbox cover carpet 76.49.05.
5. Disconnect the snap connectors (two on non-overdrive,
five on overdrive models).
6. Remove the gear lever 37.16.04.
7. Remove the seventeen bolts and washers securing the
cover to the floor and bulkhead.
8. Break the seal between the cover, floor and bulkhead
and manoeuvre the cover over the gearbox.
Refitting
9. Apply Seelastik SR51 to mating surfaces of seals,
cover, floor and bulkhead.
10. Reverse instructions I to 8.
Triumph TR6 Manual. Part No. 545277 Issue 1
76.25.03
76.25.07