Triumph TR6 PI Operation Manual page 285

OVERDRIVE -
J
TYPE
OIL SEAL - REAR
- Remove and refit
40.15.01
Removing
1. Remove the nut.
2. Remove the washer.
3. Remove the drive flange.
4. Remove the rear oil seal, using special tool Ll76A
with 7657.
Refitting
5. Fit the oil seal using special tool Ll77 with 550.
6. Refit the drive flange.
7. Refit the washer.
8. Fit a new self-locking nut and tighten to a torque of
80 to 130 Ibfft (11'1 to 18"0 kgfm).
continued
NOTE: If the vehicle has been in recent use, care should be
taken to avoid hot oil b\!rnihg the skin.
I. Remove six bolts and star washers securing the sump
to the main case.
2. Remove the gasket.
3. Remove the gauze filter.
4. Using Churchill tool L354, remove the relief valve
plug.
5. Withdraw the dashpot piston complete with its
component springs and cup.
6. Remove the residual pressure spring.
NOTE: This is the only loose spring in the general
assembly.
- - - 6
40.16.04
- Remove and refit
RELIEF VALVE AND DASHPOT ASSEMBLY
40.15.01J
40.16.04J Sheet 1
Triumph TR6 Manual. Part No. 545277 Issue f
I(j'j
_U,!,!-_~~.