Triumph TR6 PI Operation Manual page 235

SYNCHROMESH GEARBOX
GEARBOX ASSEMBLY
- Remove and refit
Removing
NT2894"
11
37.20.01
Drive the vehicle onto a ramp and isolate the battery.
Remove both front seats 76.70.04-05
Remove transmission side trim panels 76.13.06
Remove the fascia support bracket 76.46.09
Remove the gearlever 37.16.04.
Remove the carpet and the transmission cover panel.
76.25.07.
Disconnect the propeller shaft from the gearbox drive
flange.
Disconnect the speedometer drive cable.
Unscrew and remove the mounting bolts and nuts.
NOTE: On later models note the position of fixings
for the steady bracket.
**
Remove the exhaust support bracket.
Remove the mounting plate bolts.
Unscrew nine upper engine/bellhousing attachments.
Raise the ramp.
Disconnect the clutch slave cylinder push-rod from
the cross-shaft lever.
Position a ramp jack under the engine and raise the
engine/gearbox sufficient to remove the mounting
plate assembly.
Remove the remaining (seven) engine/bellhousing
attachments.
Lower the ramp and lift out the gearbox.
7.
8.
9.
1.
2.
3.
4.
5.
6.
17.
16.
15.
10.
II.
12.
13.
14.
**
37.20.01 Sheet 1
Triumph TR6 Manual.
P~rt
No. 545277 Issue 2