Triumph TR6 PI Operation Manual page 225

SLAVE CYLINDER
- Remove and refit
Removing
1. Disconnect the union at the upper end of the flexible
pipe.
2. Unscrew the flexible pipe union from the slave
cylinder and remove the clevis pin.
3. Remove the two nuts, spring washers and bolts
securing the slave cylinder flange to the mounting
bracket.
4. Withdraw the slave cylinder.
Refitting
5. Reverse instructions 1 to 4.
NOTE: that the slave cylinder push rod, should be fitted
to the centre hole in the withdrawal shaft drop arm.
6. Bleed the system.
SLAVE CYLINDER
CLUTCH
- Overhaul
33.35.07
1. Remove the slave cylinder from the car. 33.35.0 I.
2. Withdraw the rubber boot and push rod.
3. Withdraw the piston, seal, filler block and spring.
4. Thoroughly clean all components and examine the
cylinder bore. piston and filler block for signs of
damage, scoring and corrosion. If doubt exists as to
their serviceability a new slave cylinder assembly
should be obtained.
5. Lubricate the cylinder bore with clean brake fluid.
6. Fit the spring to the filler block and enter the block
(spring leading) into the bore.
7. Fit a new seal (lips leading).
8. Fit the piston (plain face leading).
9. Fit a new rubber boot and insert the push rod.
10. Fit the slave cylinder to the car 33.35.01.
11. Bleed the system 33.15.01.
Triumph TR6 Manual. Part No. 545277 Issue I
33.35.01
33.35.07