Triumph TR6 PI Operation Manual page 265

OVERDRIVE
'A'
TYPE
Un-directional clutch
76. Assembly spring into roller cage.
77. Fit inner member and engage on other end of spring.
78. Engage the slots of the inner member with the
tongues of the cage so that the spring rotates the cage
and rollers (when fitted) up the inclined face of the
inner member.
79. Place assembly, front end down, into tool Ll78 and
insert rollers through slot in tool, turning clutch
clockwise until all rollers are in place.
80. Fit thrust washer into annulus recess.
81. Fit uni-directional clutch and tool to annulus, slide
clutch from tool into its outer bearing in annulus,
remove tool.
Planet carrier
82. Rotate each of the three planet gears until a spot,
punched on the outside of each gear, is positioned
radially outwards.
83. Insert sun wheel, meshing with planets and keeping
dots in position.
84. Insert planet carrier and sun wheel into annulus,
meshing gears whilst so doing.
Continued
'40.20.l0A Sheet 7
Triumph TR6 Manual. Part No. 545277 Issue I