Triumph TR6 PI Operation Manual page 452

ALTERNATOR
- Remove and refit 86.10.02
ELECTRICAL
Removing
1.
Isolate the battery.
2. To improve access to the link bolt disconnect the
Lucar connector from the temperature transmitter.
3. Disconnect two multi-socket connectors.
4. Remove the adjustment bolt lock nut.
5. Slacken the link bolt.
6. Remove the adjustment bolt and two washers.
7. Remove the main mounting bolt nut.
8. Support the weight of the alternator and withdraw
the main mounting bolt and washer.
9.
Lift and manoeuvre the alternator from the engine
mounting bracket and drive belt.
10. Collect up the large spacer and the small spacer.
Refitting
11. To facilitate the operation tap the bush in the
alternator rear mounting lug slightly rearwards.
12. Assemble the main mounting bolt, washer, alternator
and large spacer together. Position the assembly to
the engine mounting bracket and drive belt. Insert the
main mounting bolt into the engine mounting bracket
to stabilize the assembly.
13. Position the small spacer and insert the main
mounting bolt fully.
14. Fit the main mounting bolt nut.
15. Fit the adjustment bolt with two washers positioned
either side of the link.
16. Adjust the drive belt 86.10.05.
17. Connect two multi-socket connecters.
18. Connect the battery.
Triumph TR6 Manual. Part No. ~45277 Issue I
86.10.02