Triumph TR6 PI Operation Manual page 473

ELECTRICAL
LAMPS
- HeadIamp - remove and refit 86.40.02
-------~-
-,,----
Removing
1. Insert a large screwdriver behind the rim adjacent to
the clip as shown. Twist the screwdriver to release the
rim from the clip.
2. Lift the rim from the upper retainers.
3. Remove three screws to release the retaining rim and
light unit.
4. Pull the connector block from the light unit.
Refitting
5. Reverse instructions 3 to 4.
6. Ensure that neither of the rim clip components are
bent.
7. Position the rim so that the clip components are
aligned. Locate the rim behind the upper retainers
and push to engage the clip.
Beam aiming can best be accomplished using
equipment such as Lucas 'Beamsetter', 'Lev-L-Lite' or
'Beam tester'. This service is available at Triumph
distributors or dealers and will ensure maximum road
illumination with minimum discomfort to other road users.
1. Insert a large screwdriver behind the rim adjacent to
the clip as shown. Twist the screwdriver to release the
rim from the clip.
2. Lift the rim from the upper retainers.
3. Screw 'A' positions the beam in the horizontal plane.
4. Screw 'B' controls beam height.
LAMPS
Headiamp - beam aiming
86.40.17
NT0696
86.40.02
86.40.17
Triumph TR6 Manual. Part No. 545277 Issue J