Table of Contents
Advertisement
9.
If the sprockets are out of alignment, adjust by
removing the drive key and fitting shims behind the
crankshaft sprocket. Refit the key.
NOTE: Two shim thicknesses are available 0·004 in (O·IO
mm) and 0·006 (0·52 mm).
10.
Remove the sprockets and encircle them with the
timing chain and refit to their respective positions
keeping the chain taut on the drive side. If the
original sprockets are being refitted, make sure that
punch marks
A
on the sprocket and
B
on the end of
the camshaft correspond, and Punch marks C on the
crankshaft and camshaft sprockets line-up.
II.
If new sprockets are being fitted, check their
alignment as in instructions 8 and 9, and fit them in
position and secure and make the appropriate punch
marks A, B, and C.
continued
Triumph TR6 Manual. Part No. 545277 Issue I
ENGINE
NT2
~2
NTO.20
12.65.14 Sheet 2
Hide quick links:
Advertisement
Table of Contents
