Triumph TR6 PI Operation Manual page 403

BODY
NT2S44
4
3
76.52.08
76.52.03
76.52.02
- Remove and refit
GLOVEBOX
Removing
1. Isolate the battery.
2. Detach the' bulb holder and snap connector from the
glovebox.
3. Remove the fascia reinforcement bracket - one bolt -
and two screws.
4. Slacken the clip and disconnect the cold air hose
from the heater.
5. Remove the two screws securing the floor level vent
to the fascia.
6.
Pull the cold air hoses and 'Y' piece away from the
glovebox.
7. Remove the six screws securing the glovebox to the
fascia.
8. Carefully push the glovebox downwards and remove
it from beneath the fascia.
Refitting
9. Reverse instructions 1 to 8.
Refitting
3. Reverse instructions I and 2.
Removing
I . Remove the two screws securing the check link to the
fascia.
2. Support the lid and remove the four screws securing
the lid to the hinges. Remove the lid.
GLOVEBOX LOCK
Refitting
3. Reverse instructions I and 2.
Removing
1'.
Remove the retainer - one screw and washer
2. Withdraw the lock.
- Remove and refit
- Remove and refit
GLOVEBOX LID ASSEMBLY
~.·.'L·.'~"C
~ Triumph TR6 Manual. Part No. 545277 Issue J
76.52.02
76.52.08