Triumph TR6 PI Operation Manual page 45

MAINTENANCE
(56) Inspect brake pads for wear and discs for condition
Front brakes
I. Jack up front of car and place safely on stands.
2. Remove front brake pads
~
See 70.40.02
CAUTION: Do NOT depress the brake pedal while
pads are removed.
3. Report pad condition if the friction lining has been
reduced to 0·125 inch (3 mm) or if there is not
sufficient material to provide a thickness of 0·125 in
(3 mm) at the completion of a further 3,000 miles
(5,000km) motoring.
4. Check brake discs for excessive scoring and report
this if presen
t.
5. Check brake discs for run out and report this if
it
exceeds 0·007 in (0·178 mm).
6. Refit front brake pads - See 70.40.02
7. Lower car off stands.
(57) Inspect and report brake linings for wear and drums
for condition
I. Jack up car and place safely on stands.
2. Remove road wheel - See 74.20.01.
3. Remove brake drum - See 70.10.02 (front) or
70.10.03 (rear).
4. Check brake linings for wear and report if linings are
excessively worn.
5. Check brake linings for damage and contamination by
oil or gn::ase and report if linings are damaged or
contaminated.
6. Check brake drums for wear, scoring or other damage
and report if drums are excessively worn, scored or
damaged.
7. Remove dust, oil and grease from brake drum and
backplate.
8. Retit brake drum - See 70.10.02 (front) or 70.10.03
(rear).
9. Refit road wheel - See 74.20.01.
10. Lower car off stands.
10.00.20
~ 2
.....•
~
0,
,
3
MT,271'
Triumph TR6 Manual. Part No. .545277 Issue 1
MT2719