Triumph TR6 PI Operation Manual page 262

Reassembly
Front casing
Pump
41. Fit guide pegs into holes in bottom pump face.
42. Assemble plunger, spring and pump body.
43. Insert pump assembly over guide pegs with
(q,)
flat on
plunger against guide dowel (below centre bronze
bush) and (b) hole in pump body flange adjacent to
hole in casing.
44. Drift pump into position using Ll84 (drift).
45. Remove guide pegs, fit two screws and base plug.
46. Fit sealing washer, magnetic washers and filter to
drain plug.
47. Fit and tighten drain plug and guard assembly.
Non-return valve
48. Fit ball (0'25 in dia.) on seat and tap with copper
drift to seat ball.
49. Fit valve components -
(a)
ball
(b)
plunger,
(c)
spring.
50. Fit and tighten copper washer and hexagon plug.
Continued
Triumph TR6 Manual~ Part No, 545277 Issue I
43a
OVERDRIVE 'A' TYPE
40.20.lOA Sheet 4