Triumph TR6 PI Operation Manual page 217

MANIFOLD AND EXHAUST SYSTEM
INDUCTION MANIFOLD (CARBURETIER MODELS)
Removing
I. Remove the air cleaner 19.10.0 I.
2. Remove the carburetter 19.15.11.
3. Partially drain the cooling system.
4. Slacken the two clips and disconnect the hoses from
the water pipe.
5. Remove the six nuts, lockwashers and clamps.
6.
**
Remove the three nuts and lock washers and (later
USA Markets cars only) release the Exhaust Gas
Recirculation valve connection at the induction
manifold.
**
7. Pull the manifold clear of the studs and remo,ve it
from the engine.
- Remove and refit
30.15.02
INDUCTION MANIFOLD FRONT (PETROL
INJECTION MODELS) (From Engine No. CRIE)
Refitting
8. Reverse instru"tions I to 7, ensuring that all stud nuts
are tightened to 20 to 25 Ibf ft (2'8 to 3'5 kgf m).
Refitting
9, Refit the linkage to the manifold.
10. Refit the manifold and loosely secure with the three
nuts, spring washers.and clamps.
II. Manoeuvre the manifold until the butterfly lever on
the centre manifold is spaced equidistant between the
fork lever of the front butterflies and tighten the
manifold nuts.
12. Revers!! instructions 2 to 4.
13. Adjust the throttle butterflies. 19.20.05.
30.15.02
- Remove and refit
Removing
I. Remove the air intake manifold. 19.70.01.
2. Disconnect the throttle cable from the throttle
linkage.
3. Remove the clamp bolt and clamp and withdraw the
two injectors.
4. Ease the rubber connectors to one side on
a.
the air rail
b. the balance pipe.
5. Remove the three nuts and spring washers and the
two clamps securing the manifold to the cylinder
head.
6. Slacken the front throttle adjusting screw clear of the
butterfly lever.
7. Withdraw the manifold complete with the throttle
linkage.
8. Remove the two bolts, plain and spring washers
securing the throttle linkage to the manifold and
remove the linkage.
~.·,·L'.'~~
~
Triumph TR6 Manual. Part No.
~4~277
Issue 3
30.15.02 Sheet 2