Triumph TR6 PI Operation Manual page 509

ELECTRICAL
Refitting
9. Thread the switch harness through the appropriate
steering column apertures, fascia panel aperture and
steering column clamp aperture. Do not disturb the
position of the felt strip located below the wires in
the lower half of the steering column clamp. This
operation may be facilitated by taping the ends of the
wires together. Position the switch and secure with
two screws and anti·vibration washers.
ro.
Operate the switch into the 'headlamp flash' position.
Ensure that no short is possible between the switch
'contact and the steering column.
II. Position two escutcheons. Secure with two screws.
12. Ensure that the felt strip is correctly located and
rectify if necessary.
13. Connect five snap connectors as follows:
Removing
I . Isolate the battery.
2. Later vehicles fitted with steering column lock
only:-
Inspect the steering column clamp bolts and note the
location of two nuts which are fitted with 'anti·theft'
caps. To gain access to any cap fitted uppermost
remove the adjacent speedometer 88.30.0 I or
tachometer 88.30.21. Using a wide bladed
screwdriver lever off two caps.
3. Remove two steering column clamp nuts, washers and
bolts.
4. Remove the upper' half of the steering column clamp.
5. Push the harness cover down the column slightly to
release the top clip. Pull the harness cover up the
column to release from the steering column clamp.
6. Disconnect five snap connectors.
7. Remove two screws. Withdraw two escutcheons.
8. Remove two screws and anti·vibration washers.
Remove the switch with its harness.
SWITCHES
- Column light switch - remove and refit 86.65.17
16. Fit two steering column clamp bolts, washers and
nuts. Ensure that the nuts are positioned uppermost
or lowermost as noted at operation 2 above.
17. Later vehicles fitted with steering column lock
only:-
Tap on two 'anti·theft' caps. Fit the speedometer
88.30.01 or the tachometer 88.30.21 as required.
18. Connect the battery.
i.,;,1
//!
j/
NT0715
Brown/blue switch wire to brown/white with a small
blue indent main harness wire.
Red/green switch wire to red/green main harness
wire.
Blue switch wire to blue main harness wire.
Brown switch wire to purple with a small brown
indent main harness wire.
Blue/white switch wire to blue/white main harness
wire.
14. Push the harness cover down the column to engage
into the steering column clamp. Do not disturb the
position of the felt strip. Pull the harness cover up the
column slightly to engage the top clip.
15. Position the upper half of the steering column clamp.
. 86.65.17 Sheet I
Triumph TR6 Manual. Part No. 545277 Issue
J