Table of Contents
Advertisement
ELECTRICAL
SWITCHES
Removing
I.
Carefully pull the horn push surround pad from its
retaining flange.
2.
Using a wide blade screwdriver carefully prise the
horn push unit from the steering wheel boss as
shown.
3.
Collect up the small side claw clip (if fitted).
4.
Withdraw the connection brush.
Refitting
5.
Apply petroleum jelly (vaseline) to the sliding contact
end of the connection brush.
6.
Insert the connection brush so that the sliding
contact end sweeps the slip ring.
7.
Ensure that the small side claw clip is fitted (if fitted
at operation 3 above).
8.
Align the horn push contact strip to the connection
brush. Ensure good electrical contact for the side
earth clip to the steering wheel boss. Push the horn
push unit into the steering wheel boss.
9.
Align the six recesses in the horn push surround pad
to the six steering wheel bolt heads. Carefully fit the
pad to its retaining flange.
86.65.18
- Horn push. - remove and refit
NT093Q
SWITCHES
- Reverse lamp switch - remove and refit
86.65.20
Removing
I .
Remove the gearbox LUnnel cover 76.25.07.
2.
Locate the required switch.
3.
Disconnect two Lucar connectors.
4.
Using a spanner on the hexagon, unscrew the switch.
5.
Collect up the fibre washer/washers if fitted.
Refitting
6.
Assemble with the same number of fibre washers as
originally fitted. Use new fibre washer/washers if
available.
7.
Fit the switch and fibre washer/washers to the
gearbox.
8.
Connect two Lucar connectors. The connectors may
be fitted either way round.
9.
Perform a functional check of the reverse lamp
circuit.
10.
Refit the gearbox tunnel cover 76.25.07.
86.65.18
86.65.20
Triumph TR6 Manual. Part No. 545277 Issue I
Hide quick links:
Advertisement
Table of Contents
