Triumph TR6 PI Operation Manual page 295

OVERDRlVE-J TYPE
62. Press the front bearing into the rear casing.
63. Ensure that its outer track abuts against the shoulder
in the casing.
64. Position the annulus with the inner face resting on a
suitable packing piece.
65. Using tool LlB6, press the front bearing together
with the rear casing and speedometer driving gear
onto the annulus until the bearing abuts on the
locating shoulder.
66. Fit the spacer onto the annulus.
67. Using tool Ll86, press the rear bearing onto the
annulus and into the rear casing simultaneously.
68. Fit the oil seal, using tool Ll77 with 550.
69. Press on the coupling flange.
70. Fit the washer.
71. Tighten up the self-locking nut to a torque loading of
80 to 130 Ibf ft (11·1 to 18·0 kgf m).
72. Position the spring and inner member of the
uni-directional roller clutch into the cage.
73. Locate the spring so that the cage is spring loaded in
an anti-clockwise direction when viewed from the
front.
74. Place the assembly into tool Ll78, with the open side
of the cage uppermost.
75. Move the clutch in a clockwise direction until all the
rollers are in place.
76. Refit the bronze thrust washer in the recess in the
annulus.
77. Transfer the uni-tlirectional clutch assembly from the
special assembly tool into its outer member up the
annulus.
78. Position the oil thrower.
79. Secure with the circlip.
80. Check that the clutch rotates in an anti-clockwise
direction only.
continued
40.20.IOJ Sheet 4
67
[I "'T'""
Triumph TR6 Manual. Part No. 545277 Issue I .
~
...Vl....NCl