Triumph TR6 PI Operation Manual page 328

Removing
1. Set the road wheels to 'straight ahead' position.
2. Scribe the lower end of the intermediate shaft and
the universal joint to ensure original spline location
on reassembly.
3. Remove the pinch bolt and nut securing the universal
joint to the intermediate shaft.
4. Remove the locking wire from the two bolts securing
the upper end of the intermediate shaft to the
flexible coupling and remove the two bolts.
5. Withdraw the intermediate shaft.
STEERING COLUMN INTERMEDIATE SHAFT
- Remove and refit 57.40.22
STEERING
Refitting
6. Align the previously marked scribe lines and engage
the lower end of the intermediate shaft in the
universal joint. If the shaft was removed with the
spline location unmarked, or a new shaft is being
fitted, set the road wheels and the ,steering wheel to
'straight ahead' positioris and align the flat of the
lower end of the shaft with the pinch bolt location in
the universal joint. Check that the upper two hole
flange aligns with the flexible coupling, adjust spline
location as necessary.
7. Fit the pinchbolt and nut to the universal joint. Do
not tighten at this stage.
8. Fit the two bolts to the flexible coupling ensuring
that the tail of the bonding clip is secured. Tighten
the two bolts and secure with locking wire.
9. Tighten the universal pinchbolt.
NT2512
Triumph TR6 Manual. Part No. 545277 Issue I
57.40.22