Triumph TR6 PI Operation Manual page 376

BRAKES
REAR WHEEL CYLINDER
- Remove and refit 70.60.18
Removing
1. Remove the brake shoes 70.40.03.
2. Remove the clevis pin securing the backplate lever to
the handbrake cable.
3. Disconnect the brake fluid pipe from the rear wheel
cylinder.
4. Remove the outer plate (distance washer) in a
forward direction.
5. Remove the locking plate in a rearward direction.
6. Remove the spring plate in a forward direction.
7. Remove the rubber boot at the rear of the backplate.
8. Withdraw the wheel cylinder and lever assembly from
the front of the bac.kplate.
Refitting
9. Enter the wheel cylinder and lever assembly in the
backplate.
10. Fit the rubber boot to the wheel cylinder at the rear
of the backplate.
11. Fit the spring plate entering it in the slot in the wheel
cylinder housing from the forward direction ensuring
that the angled ends are inclined away from the
backplate.
12. Fit the locking plate from the rear of the v'heel
cylinder ensuring that the slots in the rear face of the
clip engages the angled tips of the spring plate.
13. Fit the outer plate (distance washer) from the
forward direction.
14. Connect the brake pipes to the wheel cylinder.
15. Connect the handbrake cable to the wheel cylinder
lever, and secure the clevis pin with a new split pm.
16. Fit the brake shoes, brake drum and road wheel.
17. Remove the jack.
18. Bleed the brakes.
70.60.18
Triumph TR6 Manual. Part No. 545277 Issue I
•
~