Triumph TR6 PI Operation Manual page 141

Removing
1. Remove the spring clip retaining the inner cable to
the throttle pedal.
2. Disconnect the inner cable from the pedal.
3. Remove the rubber sealing washer from the brass
ferrule on the bulkhead.
4. Pull the outer cable complete through the bulkhead
hole sufficiently to enable the cable gripper to be
removed.
NOTE: The spring steel cable gripper in the bulkhead cable
clearance hole must be removed before the cpmplete
cable is withdrawn from the bulkhead, otherwise the
ferrule at the end of the outer cable will be pulled
off.
5. Remove the cable from the bulkhead.
6. Remove the split pin from the clevis pin securing the
inner cable fork to the countershaft lever.
7. Remove the lower locknut from the cable adjuster
and remove the cable complete from the bracket.
THROTILE CABLE
- Remove and refit
19.20.06
FUEL SYSTEM PI
2------4\1
Refitting
8. Thread the rubber sealing washer on to the pedal end
of the cable.
9. Thread the cable gripper over the cable and insert the
cable into the bulkhead.
10. Position the cable gripper into the bulkhead hole and
push the brass ferrule into the hole so that it is held
firm by the gripper and the shoulder is flush with the
bulkhead.
11. Reverse instructions I to 3 and 6 and 7.
12. Adjust the cable tension by means of the cable
adjuster.
10
5----4-J
Triumph TR6 Manual. Pan No. 545271 Issue I
3-8
NT2 344
\
JJ'
----\\/\\,i
1"
l»----12
NT2
J.<J
19.20.06 P.I.