Table of Contents
Advertisement
PINION OIL SEAL
- Remove and refit
Removing
1.
Remove the hypoid casing 51.25.25.
2.
Remove the drive flange.
3.
Withdraw the oil seal.
Refitting
4.
Fit a new oil seal (lip towards the pinion).
5.
Refit the drive flange.
6.
Install the hypoid casing 51.25.25.
HYPOID CASING REAR COVER GASKET
- Remove and refit
51.20.01
51.20.07
REAR AXLE
Removing
I.
Drive the car onto the ramp and raise.
2.
Remove the silencer and tail pipes 30.1 0.19.
3.
Support the hypoid casing on a jack and slacken the
two nyloc nuts and washers partially releasing the
front mountings.
4.
Remove the handbrake cable support bracket from
the hypoid casing:
5.
Remove the two rear mounting nuts.
6.
Lower the jack and axle.
7.
Remove the four nuts, bolts and spring washers and
remove the two mounting rubbers.
8.
Place a drip tray under the hypoid unit.
9.
Slacken the seven bolts securing the rear cover to the
hypoid casing. Ease the cover from the casing and
allow the oil to drain.
10.
Remove the cover.
II.
Remove the gasket and clean the mating faces.
Refitting
12.
Fit a new gasket and assemble the cover to the
hypoid casing (seven bolts).
13.
Place the four rear mounting bolts in the cover.
14.
Raise the jack under the hypoid and locate the
mounting rubbers to the studs.
15.
Locate the rear mounting rubbers to the four
mounting bolts in the rear cover and fit the four
spring washers and nuts.
16.
Fit the two plain washers and nyloc nuts.
17.
Tighten the four nyloc nuts securing the front and
rear rubber mountings.
18.
Lower the jack.
19.
Refit the handbrake support bracket.
20.
Refill the hypoid casing with new oil.
21.
Refit the silencer and tail pipes 30.10.19.
22.
Lower the ramp and drive the car off.
Triumph TR6 Manual. Part No. 545277 Issue I
4-19
51.20.01
51.20.07
Hide quick links:
Advertisement
Table of Contents
