Triumph TR6 PI Operation Manual page 116

..
ENGINE
11. Remove the set screws, bolts and nuts and spnng
washers securing the timing chain cover to the
cylinder block and engine front plate.
NOTE: The timing chain cover is located by two dowels
and two studs. ".
12. Prise the timing chain cover from the engine taking
care not to damage or distort the cover.
13. Remove the oil seal sleeve.
14. Remove the gasket.
Refitting
15. Clean the timing chain cover and engine mating faces
and fit a new gasket.,
16. Fit the timing cover locating it over the studs and
dowels. Fit the screws and bolts on their correct
positions as ilustrated and tighten evenly.
NOTE: To facilitate the fitting of the timing chain cover,
compress the timing chain tensioner with a suitable
length of wire. Care however, should be taken when
withdrawing the rod not to tear the gasket.
18. Smear the timmg cover oil seal and sleeve with oil and
with the chamfered end leading, gently press the
sleeve on to the crankshaft and through the timing
cover oil seal.
19. Reverse instructions 9 and 10.
20. Reposition the steering rack and fit and tighten the
'U' bolts 57.25.01 instructions 11 to 16, using special
tool S341.
21. Reverse instructions 1 to 7.
12.65.01 Sheet 2
Triumph TR6 Manual. Pan No. 545277 Issue I