Triumph TR6 PI Operation Manual page 125

EXPANSION TANK
EMISSION CONTROL
CONTROL PIPE - CANISTER TO TANK
- Remove and refit
17.15.19
- Remove and refit 17.15.24
I. All piping in the evaporative control and engine
breather systems is push fitted. Access to the tank
end. of the control pipe is via the luggage
compartment trim pad. When refitting pipes ensure
that all restrictors are replaced in the line and that all
connections are leak free.
Removing
I. Drain the fuel.
2. Remove the spare wheel and cover.
3. Remove the luggage compartment rear trim cover (8
screws plus two connectors for lamp).
4. Slacken the hose clip filler pipe to tank.
5. Disconnect the two connectors at the fuel gauge
transmitter.
6. Remove the six bolts securing the fuel tank to the
body and lower the fuel tank to spare wheel well.
7. Disconnect the two pipes at the tank.
8. Slacken the clips securing the tank to the fuel tank.
9. Remove the tank.
Refitting
10. Reverse instructions I to 9, ensure that all pipe
connections are leak free.
WARNING: Because of the pressence of fuel fumes avoid
naked lights or actions likely to cause sparks.
Purge pipe - canister to crankcase breather
CARBURETTER EMISSION PACK - RED
- Remove and refit
17.15.36
17.20.07
NOTE: On earlier models a larger tank is bolted to a
bracket at the rear of the luggage compartment right
trim pad and is connected by seperate pipes to each
corner of the main fuel tank.
Triumph TR6 Manual. Part No. 545277 rssue I
1. Fit the gaskets and sealing washers of this pack in
accordance with the overhaul procedure detailed in
19.15.17.
17.15.24
17.15.19
17.20.07