Triumph TR6 PI Operation Manual page 102

ENGINE
ENGINE MOUNTING - REAR CENTRE
- WITH OVERDRIVE FITTED
- Remove and refit 12.45.08
Removing
I. Isolate the battery.
2. Remove the fascia support bracket 76.46.09.
3. Turn back the carpets on the transmission cover,
remove the speedometer drive access cover and
disconnect the speedometer cable from the angle
drive.
4. Remove the speedometer angle drive from the
overdrive.
5. Slacken off all the bolts securing the transmission
cover to the floor and ease the cover off the floor in
order to provide sufficient space between the
transmission and the cover when the overdrive or
gearbox extension is raised as in instruction 9.
6. Raise the car on a ramp and remove the front exhaust
pipe together with the inner and outer intermediate
exhaust pipe assembly.
7. Remove the four nuts, bolts, plain and spring washers
securing the chassis plate to the chassis brackets
NOTE: The rear R.H. bolt can be removed after instruction
9.
8. Remove the two nuts complete with plain and spring
washers securing the mounting rubber to the
mounting plate.
9. Place a jack under the overdrive. and raise it
sufficiently to allow the chassis plate to be
removed from the studs in the rubber mounting.
~
..
10. Working within the car, release the R.H. bolt from
the captive nut welded to the exhaust pipe hanger
bracket and remove the bracket. Leave the bolt
complete with spring washer in position.
Continued
j
2.45.08 Sheet I
=
NT2 509
Triumph TR6 Manual. Part No. 545277 Jssue
J