Triumph TR6 PI Operation Manual page 31

MAINTENANCE
(5) Check/top up windscreen washer fluid level
I. Check fluid level in translucent reservoir.
If topping up is necessary:-
2. Wipe clean the reservoir cap and surrounding area.
3. Remove the reservoir cap.
4. Add soft water to bring level up to approximately
in (25-4 mm) from top of reservoir.
5. Replace reservoir cap.
CAUTION: As a precaution against freezing conditions, fill
the reservoir with a mixture of one part methylated
spirits and two parts water.
Do NOT use glycol anti-freeze solutions in the washer
reservoir, as these may discolour paintwork and
damage wiper blades and sealing rubbers.
(6) Check/top up battery
NOTE: Alternative procedures are given for each of the two
battery types that may be fitted.
I. Lift and tilt battery cover.
2. Check electrolyte level, which if correct should just
cover the separators.
If topping up is necessary:-
3. Add DISTILLED WATER until the filler tubes are
full and the trough is just covered.
4. Replace battery cover.
Alternatively: .
I. Remove battery filler plugs.
2. Check electrolyte level, which if correct should just
cover the separators.
If topping up is necessary:-
3. Add DISTILLED WATER until the separators are
just covered. DO NOT OVERFILL.
4. Replace filler plugs.
CAUTION: Paintwork can be damaged by direct contact
with the base of filler plugs.
10.00.06
1
Triumph TR6 Manuu1. PUff No. 545277 Issue 1