Triumph TR6 PI Operation Manual page 260

Clutch sliding member
18. Remove circlip and carefully separate clutch member
and drive ring assembly.
19. Remove circlip and press bearing from drive ring.
Front casing
20. Remove bronze and steel thrust washers.
Operating valve
21. Remove operating valve plug a, copper washer b, and
withdraw valve components
~
spring c, plunger d,
ball e and valve f.
22. Remove operating pistons using grips and
withdrawing with a rotary pull.
Solenoid
23. Remove two screws securing solenoid.
24. Remove solenoid, easing plunger from yoke of
operating lever.
25. Release clamp bolt and remove operating lever and
spacer.
26. Remove two nuts from studs securing solenoid
bracket.
WARNING: Remove the nuts (26) before slackening
setscrews (27) as the accumulator spring, under
tension, must be slackened progressively to avoid the
risk of personal injury.
27. Progressively slacken the two setscrews with heads
painted red securing solenoid bracket to casing.
28. Remqve solenoid bracket.
29. Collect '0' ring from cross-rod or solenoid bracket.
Continued
Triumph TR6 Manual. Part N(I. 545277 Issue I
OVERDRIVE 'A' TYPE
40.20. lOA Sheet 2