Table of Contents
Advertisement
ENGINE
Removing
1.
Isolate the battery.
2.
Remove the transmission cover 76.25.07.
3.
Place the car on a ramp and disconnect the exhaust
assembly from the centre hanger bracket.
4.
Working within the car, remove the R.H. mounting
bolt and withdraw the hanger bracket and captive
nut.
5.
Remove the L.H. mounting bolt and nut.
6.
Working beneath the car, remove the two nuts
securing the mounting to the gearbox extension.
7.
Raise the gearbox extension with a jack sufficiently
to withdraw the mounting from the chassis.
ENGINE MOUNTING - REAR CENTRE -
WITHOUT OVERDRIVE
- Remove and refit
12.45.08
NT2725
Refitting
8.
With gearbox extension still in the raised position fit
the mounting and secure to the extension with:-
a.
The captive nut and hanger bracket on the R.H.
side and
b.
The nut, bolt and spring washer on the L.H.
side.
9.
Lower the gearbox extension allowing the mounting
fixing studs to pass through the holes in the chassis
cross-member.
10.
Secure the mounting to the cross-member with the
two nuts and spring washers.
11.
Reconnect the exhaust pipe assembly to the hanger
bracket.
12.
Refit the transmission cover 76.25.07.
13.
Reconnect the battery.
14.
Remove the car from the ramp.
12.45.08 Sheet 3
~
- / - _ - J J '
Triumph TR6 Manual. Part No. 545277 Issue 1
, Nf2 5.10
Hide quick links:
Advertisement
Table of Contents
