Triumph TR6 PI Operation Manual page 399

BODY
Removing
I. Remove the door trim pad 76.34.0 I.
2. Remove the spring clip and washer and detach the
link arm from the lock.
3.
Remove the three bolts and washers and lift off the
remote control.
Refitting
4. Set the latch claw in the fully locked position as shown.
S. ReverSll instructions 2 and 3. Position the unit so that
the spring loaded lever just contacts the spring before
tightening the three bolts.
6. Refit the trim pad 76.34.01.
DOOR LOCK REMOTE CONTROL
- Remove and refit
76.37.31
DOOR PRIVATE LOCK
- Remove and refit 76.37.39
Refitting
4. Reverse instructions 1 to 3.
Removing
I. Isolate the battery.
2. Remove the three screws securing the dash side carpet
to the' A' post.
3. Drill out the rivet and remove the check strap.
Refitting
4. Press the lock into position ensuring that the collar
legs are engaged inside the door and the operating
fork is located on the door lock control rod.
5. Refit the door trim pad. 76.34.01.
NT2347
~~~I
I
I
I
NT 2480
3
76.40.27 - Remove and refit
DOOR CHECK STRAP
Removing
1. Remove the door trim pad. 76.34.01.
2. Loosely refit the regulator handle and fully raise the
glass.
3. Using a suitable tool, compress the collar legs and
withdraw the lock from the outside of the door.
Triumph TR6 Manual. Pact No. 545277 Issue]
76.37.31
76.4(L~7