Triumph TR6 PI Operation Manual page 426

WINDSCREEN WIPERS AND WASHERS
WINDSCREEN WIPER RACK
- Remove and refit
84.15.24
Removing
I. Remove two wiper arms 84.15.01.
2. Remove the harness plug from the limit switch.
3. Remove two bolts, spring washers and washers.
Remove the strap and rubber sleeve. Collect up the
rubber pad.
4. Unscrew the tubing nut.
5. Withdraw the motor and rack assembly.
6. Remove four screws. Lift off the gearbox cover.
7. Remove the crankpin spring clip by withdrawing
sideways.
8. Remove the washer.
9. Carefully withdraw the connecting rod.
10. Remove the washer.
1
I.
Remove the crosshead and rack assembly.
NT0865
Refitting
12. Position the crosshead and rack assembly to the
motor.
13. Fit the washer.
14. Lubricate the final gear crankpin with Shell Turbo 41
oil.
15. Lubricate the crosshead end of the connecting rod,
including the pin, with Ragosine Listate grease.
16. Carefully insert the connecting rod.
17. Fit the washer.
18. Fit the spring clip by inserting sideways.
19. Position the gearboX' cover. Secure with four screws.
20. Lubricate the rack with Ragosine Listate grease.
2 I. Insert the motor and rack assembly. It may be
necessary to slightly rotate each wheelbox spindle by
hand to facilitate the rack engagement.
22. Screw on the tubing nut.
23. Position the rubber pad. Locate the strap and rubber
sleeve. Secure with two bolts, spring washers and
washers.
24. Fit the harness plug to the limit switch.
25. Fit two wiper arms 84.15.01.
84.15.24
6-19
\
14
NT0864
Triumph TR6 Manual. Part No. 545277 Issue J